Ribbing
The ribbing holds the garment together where it should sit close: at the bottom, on the sleeve and at the neck.
The ribbing I use
- Knit 1, purl 1 — the most common, for edges and necks.
- Knit 1 through the back loop, purl 1 — tighter, for edges that should hold their shape.
- Knit 2, purl 2 — for cuffs.
- Knit 3 through the back loop, purl 2 — for beanies with a folded brim.
Knit through the back loop
Knit through the back loop means you insert the needle into the back leg of the stitch. It gives a tighter, clearer ribbing than an ordinary knit stitch, and the edge holds its shape instead of going slack after a few wears. The video is narrated in Norwegian.
How long it should be
The deep ribbing is what holds the wide jacket together at the bottom. On a short jacket it keeps the jacket in place over the hip instead of flaring out.
On mittens the ribbing should be long. It is there to keep the snow away from the wrist, so it has to reach well up under the jacket sleeve.
The long ribbing at the top of a top is what gives the boat neck. It lies over the shoulders and holds its shape without any decreases.
How wide it is
82 stitches measure 59 cm flat, but the ribbing pulls in to about 42 cm at rest. It goes easily over the head and still sits close to the neck.
Cosy cue
The ribbing should lie flat, not pull tight. If it is tight now, it will be tighter after washing.
Colour changes in ribbing
The purl stitches pull the previous colour up into the new stripe. The light stripe therefore gets uneven edges at both ends, and that is intended — it should look hand-knitted, not printed.
Stuck?
Send me a photo of your knitting and I'll answer.
© CosyMonday 2021–2026 · Anne-Turid Karlsrud. Tekst, illustrasjoner og video i Knittipedia er mitt eget arbeid. Les, skriv ut og lenk gjerne hit. Skal noe gjengis andre steder, ta kontakt — jeg sier som regel ja når jeg blir spurt.